The limits that you set here are valid for all channels of this sensor. Enter an integer or leave the field empty. If the free disk space of one of your drives exceeds this value, the sensor changes to the Down status. Specify an upper limit in percent for the Down status. This setting is only visible if you select Use the limits of both the sensor and the channel settings above. The sensor shows the Warning or the Down status when free space limits are above or below the limits. Use the limits of both the sensor and the channel settings : Define sensor limits that are valid for all percentage channels.The sensor only uses the limits that you define in the settings of the particular "free space in percent" channels to determine the status. Only use the limits in the settings of the percentage channels : Do not define sensor limits that are valid for all percentage channels.By default, the sensor enables percentage limits with a lower warning limit and a lower error limit. The limits are valid simultaneously, so the first limit that is breached applies.Įnable or disable a limit check for the free space in percentage channels of all drives. If you want to individually define limits for separate channels, use the limit settings in the channel settings.Īll limits that you define here are valid in addition to the limits in the particular channel settings. With limits, you can define when the sensor shows the Warning or Down status, depending on the data provided by all drives that this sensor monitors. In this section, you can set limits that are valid for all channels and all drives. For some sensors, you can explicitly define the monitoring target in the sensor settings. Usually, a sensor connects to the IP Address/DNS Name of the parent device. Choose from the lowest priority ( ) to the highest priority ( ). The highest priority is at the top of a list. This setting determines the position of the sensor in lists. The sensor has the following default tags that are automatically predefined in the sensor's settings when you add the sensor: It is not possible to enter tags with a leading plus ( +) or minus ( -) sign, nor tags with parentheses ( ()) or angle brackets ( ).įor performance reasons, it can take some minutes until you can filter for new tags that you added. You can use tags to group objects and use tag-filtered views later on. Confirm each tag with the Spacebar key, a comma, or the Enter key. You cannot change it.Įnter one or more tags. This setting is for your information only. Shows tags that the sensor inherits from its parent device, parent group, and parent probe. You can change nearly all settings on the sensor's Settings tab after creation.Ĭlick the Settings tab of a sensor to change its settings. It only shows the settings that are required to create the sensor. The Add Sensor dialog appears when you manually add a new sensor to a device.
0 Comments
Leave a Reply. |